Hardware: Hive Interface Board 5

After a failed attempt at Hive Interface board version 0.4, work has begun on version 0.5.

Analog Devices AD7124-8 Eval Board (left) connected to the Nordic nRF52840 Preview Development Kit (right)

A different approach from version 0.4 was taken. An Analog to Digital Converter (ADC) evaluation board (Analog Devices EVAL-AD7124-8SDZ) and the Nordic nRF52840 Preview Development Kit (PDK) were purchased.

This allows the software to be developed and tested before the hive interface board is designed. Initial development of the ADC driver was developed on the PI.

Goal

Create a low power, battery operated, wireless scale with extended communication range with a high performance Analog to Digital Converter (ADC) based on the Internet of Things (IOT) paradigm.

Features

• AD7124-8 24 bit ADC with 8 differential inputs

Provides independent channels for each of the 4 load cells or four scales with 4 loads cells in parallel.

• Bluetooth Low Energy (BLE) support

Uses the Nordic nRF52 32 bit ARM processor with GPIO lines and eight 16 bit ADC inputs.

• 40 pin header plug into a Pi.

The board can run from the Pi without the BMD301 as a replacement for the HX711

Development

[AD7124 Development]

Data Sheets

AD7124-8 (pdf)

http://www.analog.com/en/design-center/design-tools-and-calculators/converter-tools.html