Difference between revisions of "Solder shield and connectors"
| Line 7: | Line 7: | ||
#Turn board over and bend the tab nearest the 4 holes toward the center of the board. Bend this tab all the way over so it will not interfere with installing the connector. | #Turn board over and bend the tab nearest the 4 holes toward the center of the board. Bend this tab all the way over so it will not interfere with installing the connector. | ||
#Solder all 5 tabs. | #Solder all 5 tabs. | ||
| − | #Place a piece of | + | #Place a piece of tape over the tab that was bent over. |
<br clear=all> | <br clear=all> | ||
| Line 15: | Line 15: | ||
<br clear=all> | <br clear=all> | ||
| + | [[File:Hx711_solder_connectors.jpg|thumb|600px|Solder terminal blocks.]] | ||
| + | Turn the board over so the component side is up and solder the pins on the terminal blocks. | ||
Revision as of 21:02, 6 December 2014
Solder shield and connectors on HX711 board. This is already done on the developer kits, This step is only necessary if you obtain parts independently.
- Place shield over the components making sure all 5 tabs go into the holes.
- Turn board over and bend the tab nearest the 4 holes toward the center of the board. Bend this tab all the way over so it will not interfere with installing the connector.
- Solder all 5 tabs.
- Place a piece of tape over the tab that was bent over.
The connector pins are too large for the holes. Each connector pin need to be squeezed slightly with pliers.
Turn the board over so the component side is up and solder the pins on the terminal blocks.
