Difference between revisions of "Sensors: DHT22"
(→Pull Up Resistor) |
(→Read Time) |
||
| Line 22: | Line 22: | ||
==Read Time== | ==Read Time== | ||
| − | You must wait at least 2 seconds before reading again or you will get a bad read ( | + | You must wait at least 2 seconds before reading again or you will get a bad read (the checksum will fail). |
The new spec sheet: "the interval of whole process must beyond 2 seconds." | The new spec sheet: "the interval of whole process must beyond 2 seconds." | ||
Revision as of 04:12, 18 January 2016
The AM2302 (DHT22) is a 3 wire (Vcc, data, gnd) temperature and humidity sensor manufactured by Aosong.
Spec Sheets
AM2302 spec sheet
New AM2302/DHT22 spec sheet
Test Results
http://www.kandrsmith.org/RJS/Misc/calib_dht22.html
Pull Up Resistor
The Adafruit module (left) includes a 5.1K pull up resistor and a bypass capacitor.
The Pi does have internal pull ups that are turned on.
The new DHT22 spec sheet shows it as 1K in Figure 5. The old spec sheet said: "single bus usually require an external about 5.1kΩ pull-up resistor."
Read Time
You must wait at least 2 seconds before reading again or you will get a bad read (the checksum will fail).
The new spec sheet: "the interval of whole process must beyond 2 seconds."
The old spec sheet:
3.Read the sensor minimum time interval for the 2S; read interval is less than 2S, may cause the temperature and humidity are not allowed or communication is unsuccessful, etc.. 4.Temperature and humidity values are each read out the results of the last measurement For real-time data that need continuous read twice, we recommend repeatedly to read sensors, and each read sensor interval is greater than 2 seconds to obtain accurate data.
