Difference between revisions of "Hardware: PCB Assembly"
(→Assembly) |
(→Parts) |
||
| Line 3: | Line 3: | ||
==Parts== | ==Parts== | ||
| + | [[Media:DevKitPartsList20160116.pdf| Parts List]] | ||
| − | + | [[Media:PT-JGT(X)(XXX).jpg| Mechanical Drawing for RJ connectors.]] | |
| − | |||
==Board Layout== | ==Board Layout== | ||
Revision as of 01:56, 18 January 2016
Contents
Parts
Mechanical Drawing for RJ connectors.
Board Layout
Assembly
- insert the 2x20 female header from the bottom side of the board.
- Solder the header on the top (component, silk screen) side of the board.
- Install the following resistors:
- R 330
- R 1K
- R 1K
- R 2.2K
- R 2.2K
- R 200K
- Install RJ1 and RJ2. Be very careful to check that all the leads are in the holes before you snap it in place.
- Install 1x4 and 1x6 male header.
- Install LED.
- Install power supply if used.
Power Supply 1
- Install four 1x2 male headers.
- Install blue screw terminal block.
power Supply 2
- Install Fulree voltage regulator
- Install green spring terminal block.
