Difference between revisions of "Hardware: Hive Interface Board 1.0"
| Line 3: | Line 3: | ||
==Features== | ==Features== | ||
*Add [[Real Time Clock RTC | Real Time Clock (RTC)]] support so DS3231 will plug into header H2 without modification. | *Add [[Real Time Clock RTC | Real Time Clock (RTC)]] support so DS3231 will plug into header H2 without modification. | ||
| − | *Change 1-Wire connection to Pi's default 1-Wire GPIO | + | *Change 1-Wire connection to Pi's default 1-Wire GPIO by swapping GPIO pin for LED from pin 7 (default 1-wire) to pin 11. |
| − | *Added Chip Enable signal to SPI bus signals on | + | *Added Chip Enable signal to SPI bus signals on H7. |
| − | * | + | *Increase hole size for blue 12 VDC power connector from .038" to .042". |
== | == | ||
Revision as of 02:50, 30 May 2018
Ver 1.0 of the Hive Interface Board. As suggested by the 1.0 designation, this should be the final release of this design.
Features
- Add Real Time Clock (RTC) support so DS3231 will plug into header H2 without modification.
- Change 1-Wire connection to Pi's default 1-Wire GPIO by swapping GPIO pin for LED from pin 7 (default 1-wire) to pin 11.
- Added Chip Enable signal to SPI bus signals on H7.
- Increase hole size for blue 12 VDC power connector from .038" to .042".
==
