Difference between revisions of "Cellular Communication"
(Create Wiki for Cellular Communication) |
|||
| Line 3: | Line 3: | ||
My setup for this is: | My setup for this is: | ||
| − | + | *Raspberry Pi | |
| − | + | *HAT board | |
| − | + | *Weighing cells | |
| − | + | *2 x DHT22 Temperatur / Humidity sensors | |
| − | + | *TSL2591 Lux sensor | |
| − | + | *Edimax E180 3G modem | |
| − | + | *WiFi from Raspberry | |
There are several things to think about | There are several things to think about | ||
| − | + | #Is this the only hive to be connected to internet. | |
| − | + | #If there is more that one, you need to set it up as a router. | |
| − | + | #If there is only two hives a ethernet cable between would be the most power effeciant. | |
| − | + | #If there is more than two, you need a ethernet hub or using wifi between hives (wifi use a lot of power) | |
| − | 1. Only one hive connecting | + | 1. Only one hive connecting<br> |
| − | + | [http://shkspr.mobi/blog/2012/07/3g-internet-on-raspberry-pi-success/ Setting up for connecting to Internet] | |
| − | [http://shkspr.mobi/blog/2012/07/3g-internet-on-raspberry-pi-success/] | ||
Revision as of 06:51, 18 January 2016
The main goal for this is to have a hive sending data in areas not covered with network cable to house or outside WiFi range. There is also a problem with sites without AC power. This is also covered in the section for Solar Panel.
My setup for this is:
- Raspberry Pi
- HAT board
- Weighing cells
- 2 x DHT22 Temperatur / Humidity sensors
- TSL2591 Lux sensor
- Edimax E180 3G modem
- WiFi from Raspberry
There are several things to think about
- Is this the only hive to be connected to internet.
- If there is more that one, you need to set it up as a router.
- If there is only two hives a ethernet cable between would be the most power effeciant.
- If there is more than two, you need a ethernet hub or using wifi between hives (wifi use a lot of power)
1. Only one hive connecting
Setting up for connecting to Internet
