Difference between revisions of "Hardware: Sensor Wiring"
(→Load Cells) |
(→Load Cells) |
||
| Line 11: | Line 11: | ||
[[File:Loadcell connector 3.jpg|thumb|right|500px]] | [[File:Loadcell connector 3.jpg|thumb|right|500px]] | ||
| − | #Remove any | + | #Remove any heat shrink from the load cell cable. |
#Cut off the drain wire. | #Cut off the drain wire. | ||
| − | #Spread out the four wires and arrange in | + | #Spread out the four wires and arrange them in Red, White, Green, Black order. |
| − | Red, White, Green, Black. | + | #Gently flatten the cable with a pair of pliers. |
| − | + | #Trim the wires so they extend approximately 1/4 inch ast the jacket. | |
<br clear=all> | <br clear=all> | ||
Revision as of 02:22, 4 December 2015
The Developers Kit uses RJ14 (6p4c) connectors for most of the sensors. The Registered Jack (RJ) series connectors install using an inexpensive crimping tool.
Load Cells
- Remove any heat shrink from the load cell cable.
- Cut off the drain wire.
- Spread out the four wires and arrange them in Red, White, Green, Black order.
- Gently flatten the cable with a pair of pliers.
- Trim the wires so they extend approximately 1/4 inch ast the jacket.
DHT22 Temperature and Humidity Sensor
