Difference between revisions of "Solder shield and connectors"
| Line 8: | Line 8: | ||
#Solder all 5 tabs. | #Solder all 5 tabs. | ||
#Place a piece of tabe over the tab that was bent over. | #Place a piece of tabe over the tab that was bent over. | ||
| + | <br clear=all> | ||
| + | |||
| + | [[File:Hx711_connectors1.jpg|thumb|600px| Prepare connectors for installation on HX711 board.]] | ||
| + | The connector pins are too large for the holes. Each connector pin need to be squeezed slightly with pliers. | ||
| + | |||
| + | |||
| + | <br clear=all> | ||
Revision as of 20:57, 6 December 2014
Solder shield and connectors on HX711 board. This is already done on the developer kits, This step is only necessary if you obtain parts independently.
- Place shield over the components making sure all 5 tabs go into the holes.
- Turn board over and bend the tab nearest the 4 holes toward the center of the board. Bend this tab all the way over so it will not interfere with installing the connector.
- Solder all 5 tabs.
- Place a piece of tabe over the tab that was bent over.
The connector pins are too large for the holes. Each connector pin need to be squeezed slightly with pliers.
